In ACE per Head mode the dashboard shows the 4 toolheads at the bottom, and above them the ACE units connected to each toolhead as cards.
Controls
Display
Display in the top row opens the familiar display mirror when running a PAxx firmware.
ACE cards
Heater
The heater icon shows the heater controls inside the card. Here you can change temperature and duration, and start or stop the drying process.
Slots
The slots of the ACE unit are shown side by side. When you insert a spool, the slot shows either Ready or the RFID information. Click a slot to set or change the filament.
Load
Load below a slot preloads that slot.
Toolhead cards
Material & color
If loaded, the card shows the loaded material and color. On feeder heads you can set the color by clicking the color circle.
Unload
Unload unloads the head.
Feeder / ACE
Feeder switches the head between feeder and ACE mode. Please connect the tubes accordingly. In ACE mode you can select the connected unit. BG enables the Parked Head Swap for that ACE unit.
Unload all
Unload all unloads all heads one after another.
Filament Snapshots
Under Filament Snapshots you can save filament loadouts and restore them at the push of a button. The material information can be restored as well.